Reprint
Design and Control of Power Converters 2019
Edited by
July 2021
402 pages
- ISBN978-3-0365-1563-2 (Hardback)
- ISBN978-3-0365-1564-9 (PDF)
This book is a reprint of the Special Issue Design and Control of Power Converters 2019 that was published in
Chemistry & Materials Science
Engineering
Environmental & Earth Sciences
Physical Sciences
Summary
In this book, 20 papers focused on different fields of power electronics are gathered. Approximately half of the papers are focused on different control issues and techniques, ranging from the computer-aided design of digital compensators to more specific approaches such as fuzzy or sliding control techniques. The rest of the papers are focused on the design of novel topologies. The fields in which these controls and topologies are applied are varied: MMCs, photovoltaic systems, supercapacitors and traction systems, LEDs, wireless power transfer, etc.
Format
- Hardback
License
© 2022 by the authors; CC BY-NC-ND license
Keywords
vehicle-grid coupling system; low frequency oscillation; traction line-side converter (LSC); model-based predictive current control (MBPCC); dSPACE semi-physical verification; switching converters; sliding-mode control; current-mode control; hysteresis control; PV-connected inverter; MPPT; SPPT; adaptive hysteresis current control; hybrid storage systems; power electronic converters; half-bridge current-source converters; supercapacitors; cascaded H-bridge (CHB); dc-link voltage balance control; multilevel converter; power control; single-phase system; pulsating output current; light emitting diode (LED); peak to average ratio (PTAR); power factor correction; harmonic injection; modelling; feedback loop control; three-port converter; linear active disturbance rejection control; virtual damping; linear extended state observer; power converters; digital control; design space; frequency domain; switched affine systems; hybrid systems; fuzzy identification; fuzzy modeling; two degrees of freedom; fuzzy model predictive control; PLC; bus converter; DC bus; LED driver; buck converter; inversion formulae; phase margin; gain crossover frequency; wireless power transfer; inductive power transfer; Pareto optimality; coil design; magnetics design; GaN-based inverter and converter; zeta inverter; active clamp; synchronous rectification; power efficiency; circulating current; fuzzy; proportional integral; proportional resonant; MMC; DC–DC converter; experimental verification; Inductor–Diode; Inductor–Capacitor–Diode; nonisolated; step-down; two-stage buck converter; voltage regulation; power electronic converter; AC/AC converter; matrix converter; reliability; DPWM; MPPT; photovoltaic power system; MPPT; differential flatness; nonlinear control; networked power converters; PFC converters; reactive power resources; supervisory controller; HIL Testbed; binary particle swarm optimization (BPSO); nonsingular terminal sliding mode control (NTSMC); global best solution; total harmonic distortion (THD); DC–AC converter; decoupling; reduced order generalized integrator (ROGI); optimal gain; distributed power generation system (DPGS); grid-connected voltage source converters (GC-VSCs)